Burnham 103339-01 Flame Sensor

Burnham 103339-01 Flame Sensor

Burnham Boiler

  • $84.00


The Burnham 103339-01 Flame Sensor Kit is the OEM replacement flame sensor and gasket kit for Burnham Alpine condensing boilers. The kit contains the flame sensor rod with its mounting flange, a flange gasket and the mounting screws, everything needed to swap the sensor in one step. The flame sensor tells the boiler's control that burner flame is present. The rod sits in the flame and carries a tiny signal back to the control, and the moment that signal disappears the control shuts the gas valve and ends the cycle. It is a small part with a big job, because a boiler that cannot prove flame will not stay lit.

A weak or failing flame sensor causes some of the most frustrating service calls on a condensing boiler. The boiler purges, lights, and then shuts down within a few seconds with a flame failure lockout, or it runs for days and then starts locking out on cold starts. The rod can erode, scale, crack or lose its connection, and the gasket can harden. The 103339-01 is the sensor kit for the Alpine, and the companion service parts are the 103005-01 igniter kit and the 105756-01, 105757-01 and 105758-01 blower replacement kits, which are sized by Alpine model. Other Burnham flame sensor kits exist for other boiler sizes, such as the 103310-01 and the 105798-01, so match the kit to the boiler by model and serial number.

Before replacing the sensor, check the basics: gas supply, a clear vent and combustion air intake, a draining condensate trap, a good ground path and a tight wire connection at the sensor. Then inspect the rod. A rod that is bent, eroded, cracked or heavily coated should be replaced rather than cleaned. Shut off the power and the gas, remove the old sensor, fit the new 103339-01 with the new gasket and the supplied screws, reconnect the lead, restore power and gas, and run the boiler through a full sequence while watching the flame signal on the control. The gasket should be replaced every time the sensor is removed.

Key Benefits

  • Complete Replacement Kit: Flame sensor rod, gasket and mounting screws in one kit, so the sensor is replaced with the right seal.
  • Restores Flame Proving: A fresh sensor gives the control a clean flame signal and ends flame failure lockouts caused by a worn rod.
  • Alpine OEM Part: A factory Burnham kit for the Alpine condensing boiler, built to the original sensor specification.
  • Quick Service Item: A short, low-cost repair that is easy to stock and easy to replace during annual service.

Common Questions

  • What boilers is the 103339-01 for? Burnham Alpine condensing boilers. Other Burnham boilers use other sensor kits, such as the 103310-01 or 105798-01.
  • What is in the kit? The flame sensor, the gasket and the mounting screws.
  • Should the igniter be replaced with the sensor? Not automatically. If the boiler has years of service or ignition symptoms, the 103005-01 igniter kit is the companion part.

Disclaimer: While we strive for 100% accuracy, product data and specifications are subject to change. Please contact our team to confirm compatibility or technical details before purchasing.