Copeland 914-0053-00 Start Capacitor

The Copeland 914-0053-00 Start Capacitor is a high-torque electrical component engineered for single-phase HVAC compressor motors. Rated at 145-175 Microfarads (MFD) and 165Vac, this round start capacitor provides the necessary phase shift to overcome initial inertia during the start-up cycle. Designed specifically for Copeland refrigeration compressors and Emerson-branded systems, it ensures rapid motor acceleration, reducing the duration of locked rotor amperage (LRA) and protecting internal windings from excessive heat saturation.

Built with a robust phenolic housing, the 914-0053-00 operates within a wide temperature range of -40°F to 158°F, making it suitable for demanding commercial and residential environments. As a veteran-grade OEM replacement part, it is critical for restoring system efficiency when a compressor exhibits "hard starting" or an audible hum without turnover. Professional installation is recommended to verify the potential relay and ensure the capacitor is correctly removed from the circuit once the motor reaches 75% of its rated speed.

Key Benefits:

• Optimized Starting Torque: Provides a 145-175 uF capacitance boost for reliable compressor ignition under high head pressure.
• Precise Voltage Rating: The 165V dual-voltage compatibility ensures stability during the momentary high-amperage start-up phase.
• OEM Compatibility: Exact fit for Copeland 914-0053-00, eliminating the need for field modifications or universal brackets.
• Thermal Resilience: Proven performance in extreme ambient conditions, maintaining accurate MFD tolerances.

Common Questions:

Can I use this capacitor if my current unit is rated for 110V?
Yes, a 165Vac capacitor can safely replace a 110Vac or 125Vac unit, as the voltage rating represents the maximum threshold the component can handle during the start cycle.

Why did my original 914-0053-00 fail?
Frequent failures are often caused by a welded potential relay or short-cycling. If the capacitor stays in the circuit longer than three seconds, it will overheat and vent.

Does this unit require a bleed resistor?
Standard practice for HVACR technicians is to ensure a 15k-18k ohm resistor is installed across the terminals to discharge residual voltage and protect the relay contacts.

This item is not eligible for free shipping.

Disclaimer: While we strive for 100% accuracy, product data and specifications are subject to change. Please contact our team to confirm compatibility or technical details before purchasing.