Burnham Boiler 105883-01 Temperature Sensor

Burnham Boiler 105883-01 Temperature Sensor

Burnham Boiler

  • $44.44


The Burnham Boiler 105883-01 Flue Temperature Sensor is the OEM probe that reports flue gas temperature to the boiler control. It is the sensor used on the K2 series condensing boilers and is part of the K2, K2 Combi and X-C service kit that Burnham publishes for annual maintenance. The probe plugs into the control through a white connector and extends a short sensing probe into the flue outlet, where it measures the temperature of the exhaust leaving the heat exchanger.

The control uses that reading in two ways. During normal operation it follows flue gas temperature as a guide to combustion and heat-exchanger condition, and if the exhaust climbs past a safe limit it can reduce firing rate or shut the burner down to protect the venting and the heat exchanger. A drifting or open sensor therefore shows up as a flue temperature fault, a nuisance lockout, or a boiler that derates for no visible reason. Because the sensor sits in the hottest part of the exhaust path, the probe and its lead see constant heat and condensate exposure, so a corroded probe, a brittle wire jacket or a loose connector are the usual reasons for replacement. A visual check of the sensor and its seal belongs in every annual service, and a quick comparison of the reading against a calibrated combustion analyzer confirms whether the sensor tracks the real exhaust temperature.

Replace the 105883-01 when a diagnostic points to the flue sensor, when the probe is corroded, or when the connector or wiring has been damaged. Disconnect power first, seat the probe the same way the original sat, and keep the sensor wire clear of hot surfaces. On CHG and Freedom boilers the flue gas sensor is a different part, 101015-01, so match the boiler series before ordering.

Key Benefits

  • Accurate Flue Readings: The probe reports flue gas temperature to the control so firing rate and safety limits act on real exhaust data.
  • K2 Service Part: Specified by Burnham for the K2 series and carried in the K2 service kit parts list.
  • Plug-In Connection: A white connector on the lead mates with the control harness, so no rewiring is involved.
  • Protects the Venting: A working sensor lets the control back off or stop the burner before venting and the heat exchanger see excess heat.

Common Questions

  • What does this sensor do?: It measures flue gas temperature and sends the value to the boiler control for combustion and safety limit decisions.
  • Is it the same sensor as the CHG and Freedom boilers use?: No. Those boilers use 101015-01; the 105883-01 is for the K2 series.
  • What symptoms point to a bad flue sensor?: A flue temperature fault code, an unexplained lockout, or readings that do not change as the boiler runs.

Disclaimer: While we strive for 100% accuracy, product data and specifications are subject to change. Please contact our team to confirm compatibility or technical details before purchasing.