Burnham Boiler 109628-01 SS Burner Kit
The Burnham Boiler 109628-01 SS Main Burner Kit is the OEM set of three stainless steel main burner tubes for a Burnham gas-fired boiler. Each tube is a straight, slotted burner tube that receives gas from the manifold and orifices, draws in combustion air, and spreads the mixture along its length so it burns as a steady row of small blue flames beneath the heat exchanger. Stainless steel construction resists the scaling and corrosion that eventually wear out ordinary steel tubes. Three tubes in a single kit suit a boiler whose burner bank uses three tubes, so count the burners in the unit first.
Burner tubes fail slowly. Rust flakes can clog the burner ports, a warped or cracked tube produces uneven flame pattern and flame lift, and a partly blocked tube can cause delayed ignition or flame rollout. Technicians usually see yellow tips, lazy flames, soot on the heat exchanger, or a boiler that lights roughly and trips on a rollout switch. Replacing the burner tubes as a set brings the flame back to an even, blue pattern across the whole burner bank.
The 109628-01 supplies three tubes in one kit. Shut off the gas supply and power, compare the tube count, length and port layout against the burners in the boiler before ordering, and install the tubes square in their retaining slots so the orifices line up cleanly with each tube inlet. After the job, light the boiler, verify a clean blue flame pattern, check the manifold pressure, and run a combustion test before leaving. Replace all three tubes together instead of one at a time: tubes in a bank age at the same rate, and mixing new and old burner tubes leaves uneven flame patterns and invites repeat service. Clean the orifices, vacuum the burner compartment and check the ignitor position while the tubes are out, and inspect the heat exchanger surfaces for soot that signals earlier poor combustion.
Key Benefits
- Three Tubes in One Kit: The kit supplies three burner tubes so a bank can be renewed together with a single part number.
- Stainless Steel: Stainless steel resists the scale and corrosion that clog burner ports on older tubes.
- Even Flame Pattern: New tubes restore a uniform row of blue flames and reduce flame lift and delayed ignition.
- OEM Part Number: Supplied under Burnham number 109628-01 so the tubes match the factory design.
Common Questions
- How many tubes are in the kit?: Three stainless steel burner tubes.
- What signs say burner tubes need replacing?: Yellow flame tips, an uneven flame pattern, soot on the heat exchanger, or rough lighting are common signs.
- How do I confirm it matches my boiler?: Compare the tube count, length and port layout with the burners installed, and contact our team with the boiler model if you are unsure.
Disclaimer: While we strive for 100% accuracy, product data and specifications are subject to change. Please contact our team to confirm compatibility or technical details before purchasing.