Carrier 326058-757 Inducer Assembly

The Carrier 326058-757 Inducer Assembly is a factory-authorized two-stage draft inducer motor designed for direct integration into high-efficiency gas furnaces. As the direct replacement for HC27CB122, this 115V, 3300 RPM assembly ensures precise flue-gas evacuation and maintains the negative pressure required to close the pressure switch and initiate the ignition sequence. This OEM inducer assembly features a 0.035 HP thermally protected motor and includes a pre-installed 3 MFD capacitor to facilitate high-torque startups in cold-weather conditions. For technicians, this complete draft inducer kit eliminates the need for separate motor-to-housing alignment, providing a drop-in solution that fits Carrier, Bryant, and Payne furnace models. Utilizing a robust Fasco JE1D015N motor, it effectively manages airflow across both heating stages to prevent pressure switch trips and combustion instability.

• Seamless Compatibility: Serves as the factory-spec direct replacement for HC27CB122 and older part numbers 325270-772 and 326058-707, ensuring exact mounting alignments.
• Enhanced Two-Stage Performance: Optimized for variable-load furnaces, providing the necessary static pressure for both low and high-fire heating cycles.
• Reliable Cold Starts: Equipped with a 3 MFD run capacitor and thermal protection to prevent motor burnout during demanding winter operations.
• OEM Engineering: Built to original equipment tolerances to reduce vibration-induced noise and maximize the service life of the draft inducer motor.
• Efficient Exhaust Management: Specifically engineered to pull combustion air through the heat exchanger and vent flue gases safely out of the system.

Is the 326058-757 a direct fit for the HC27CB122?
Yes, the Carrier 326058-757 is the technical successor and direct replacement for the HC27CB122. It mimics the original footprint and electrical connections for a standard installation.

What are the signs of a failing two-stage inducer motor?
Technicians typically look for screeching bearings, a seized motor shaft, or intermittent pressure switch fault codes. If the motor fails to reach its 3300 RPM target, the system will lock out the ignition cycle.

Does this assembly include the necessary capacitor?
This inducer motor assembly includes a pre-wired 3 MFD capacitor, though technicians should always verify the gasket condition or use high-temperature silicone during the mounting process to ensure a gas-tight seal.

This item is not eligible for free shipping.

Disclaimer: While we strive for 100% accuracy, product data and specifications are subject to change. Please contact our team to confirm compatibility or technical details before purchasing.