Trane CAB1150 Wiring Harness
The Trane CAB1150 Wiring Harness Extension 78.74 In. is a genuine OEM Trane long extension harness that adds 78.74 inches of reach, about two meters or 200 cm, between two points in a Trane wiring run. It is built as a male-to-female extension, with a keyed plug end and a multi-cavity receptacle end, so it goes in line with an existing harness instead of replacing it. In the product photo the CAB1150 is a tan-gray jacketed cable with a black keyed plug housing on one end and a black multi-cavity receptacle housing, with a violet-colored cavity insert, on the other. A long extension like this earns its place when a board, sensor or control has been moved well away from where the factory harness ends, or when a short lead has been cut back and a splice is not an acceptable repair.
Distributors also list this harness as CAB01150, the number that shows up in many parts searches. The two numbers point to the same 78.74 in. extension. Length is the main difference inside this family: the CAB1149 (also listed as CAB01149) is the 39.37 in. version, while the CAB1150 doubles that reach. We also carry the CAB1155 extension as a separate listing. Each Trane extension number is its own harness, so confirm the connector ends and measure the actual route, including every bend, before you decide between the long and the short length.
A long harness needs good routing. With power locked out at the unit disconnect, inspect both connector faces for bent pins, backed-out terminals, melted housings and corrosion, then seat each end until the locking tab clicks. Run the wiring harness away from sharp edges, blower wheels, fan blades and hot surfaces, and support it with ties at regular intervals so the cable never hangs from a connector. Coil any excess neatly instead of leaving a loop where it can snag. An end-to-end continuity check of each conductor on the bench catches a bad extension before it goes into the cabinet. Intermittent faults and lost signals that come and go with vibration usually trace back to a loose or damaged connection, which is why a factory extension with proper connectors beats a field splice every time.
Key Benefits
- Factory-Matched Extension: A genuine OEM Trane harness extension with proper connector housings on both ends, not a generic jumper.
- Long Reach: 78.74 in. (200 cm) of cable, double the CAB1149, for relocated boards, sensors and controls.
- No Field Splicing: Keeps the circuit on factory connectors so there is no splicing, crimping or taped repair in the run.
- Clear Cross-Reference: Listed as CAB1150 and also known as CAB01150, so either number finds the right harness.
Common Questions
- How long is the CAB1150? The CAB1150 is a 78.74 in. extension harness, about two meters or 200 cm.
- Is the CAB1150 the same part as the CAB01150? Yes. CAB01150 is the other number this 78.74 in. extension is listed under. For half the length, the CAB1149 is the 39.37 in. extension.
- Which Trane models does the CAB1150 fit? Fit comes down to the connector ends and the route length rather than a model list. Match the connector style on the harness you are extending, measure the full run, and confirm it against the unit model and serial number before ordering.
Disclaimer: While we strive for 100% accuracy, product data and specifications are subject to change. Please contact our team to confirm compatibility or technical details before purchasing.